Another Trip to Dillon

Some time through Feb 14-28th other then the 17-18th, ill be back in Arizona to visit the Dillon Precision Factory, and pick up a few tools.

more testing

started seating the bullets down to 1.125, it slowly rose to 1.138 after about 15 rounds and down to 3.7gr of Alliant Bullseye powder, the casings don't fly out of the gun all that far but they are fairly accurate

Loaded a few more 9mm 115gr

Did a little more testing at 3.8-3.9 grains of alliant bullseye, louder then remington rounds still and eject a little farther, and waiting for my chronometer still

Dillon Prescision Visit

My wanderings around the Dillon Precision store room middle of September

Owner Mike Dillon's dog (very shy)

Waiting

Waiting to make the other 800 9mm ammo till I can pick up a chrony and see the fps on my current made up rounds

Setup of XL650 and a few operational videos

9mm Luger, 50 rounds reloaded

9mm, Winchester 115gr bullets, Alliant Bullseye 4.4gr charge, CCI 500 primers

Minor fixes to XL650

replaced the spent primer cup with a primer drop tube to a bucket below the bench along with a bolt and stainless steel pipe on the bolt to allow the tube to roll and keep it off the completed bullet basket, also a tube over the unused primer tray to stop the loss of primers from flying off the tray