Needle Bearing and 2 washers for the shell-plate to move a bit smoother to stations
After you Add the Needle bearing and washers you have to modify the ejector wire that sits around the bolt head, otherwise the shell-plate will lock up trying to eject the finished ammunition or pop out of the hole and sit too close to the station one locator and stop new cases from entering which will cause a lock up as well. (Note: This combination of bends did not work but it was very close to being right, it is now right i will try to get a pic of it maybe with some measurements)
My 4$ solution to the powder bar adjustment, since home depot didn't have any that would directly fit over the 7/16 head.
No comments:
Post a Comment